The control panel unlocks by holding down the lock controls button for three seconds.
Missing self cleaning oven lock on oven door ge.
Disconnect power to range for 30 seconds.
Wait approximately 30 minutes for the oven to cool and try to unlock the door.
If you suspect that the sensor is at fault you should first remove the power to the oven for a few moments and then reconnect.
Try pushing inwards on the top of the door while programing a clean cycle to see if the door will lock nbsp.
A ge profile oven offers ways to lock the control panel as well as the oven door.
When this happens your oven will not clean anymore until you have restored the lock.
Hold the oven door tightly closed and.
Reconnect power and see if door will unlatch.
Some models have an oven door latch that must be slid left to unlock.
If the oven is still locked press the self cleaning button again to start the cycle.
On the oven control panel press the clock or set clock button and the cancel off button at the same time and hold for 10 seconds.
Sometimes they can get gummed up from food or dust particles and they will no longer lock.
Our ge double ovens electric will stay locked for about 15 30 our ge double ovens electric will stay locked for about 15 30 seconds then the self cleaning mode will shut off and the oven will unlock.
Slide the oven away from the wall and disconnect the electrical cord from the power outlet.
Remove the burner grates and lift the hinged oven top.
It is important to note that you must wait for the oven to cool after running the self cleaning function.
If this doesn t work open the oven door and look for the oven light switch inside the oven.
Door will not unlock after self cleaning.
Remove the cover over the locking mechanism.
Use the bracing rod to hold the top open.
To unlock an oven after cleaning wait for it to cool.
Let it go for 30 seconds and then cancel the self cleaning cycle.
In order to diagnose if the lock motor is getting voltage after setting and starting a clean cycle will require a voltage meter.
As a safety precaution virtually all self cleaning ovens have a door locking mechanism that automatically secures the door whenever the cleaning function is activated.
The voltage can be measure to the door lock motor from the electronic oven control board.
Most electronic control ovens will display a fault code to indicate that the sensor has failed.
If the door does not lock it could have a faulty electronic oven control or a faulty door lock motor assembly.
Try the following to unlock the door.
It will beep read more.
If door does not unlatch and you do not have food in the oven set the oven up to clean for 1 2 hours.
