Reverse the drill bit when you re done to get the debris out of the hole.
Mount sign on brick wall.
Align the bottom and side of the sign with the horizontal and vertical lines.
Hold the sign against the face of the brick wall.
Using the proper diameter carbide drill bit drill a hole in the base material a minimum of 1 2 deeper than the screw.
In this short video we will demonstrate just how easy it.
Remember that the hole size should be slightly smaller than the diameter of the.
Clean out the hole with.
Please try again later.
Published on jan 28 2013.
Forget hiring someone to hang your new custom sign for you.
Add a screw to the middle of the masonry anchor by drilling it in.
Use a carbide bit and hammer drill.
Using tapcons are fairly simple.
Use only the screws designed for use with that masonry anchor because using a screw that s too big could damage the masonry anchor and using a screw that s too small may not provide the support you need.
Drill slightly deeper than your screws anchors are long.