Mounting A Shelf On Lathe And Plaster Walls

We just finished a small kitchen remodel and i was going to put up a metal bookshelf potrack.

Mounting a shelf on lathe and plaster walls.

You ll know this is happening if the anchor flange starts to depress the surface of the plaster or drywall. Simply hanging something heavy on a plaster wall can result in damage to the wall and the object if you don t tap into the supporting structure behind the plaster. Hanging things on lath and plaster walls is a tricky business. If it is being mounted to a stud use wood screws.

Take care not to overtighten. Screw the bracket into place. Driving anything much larger than a pin nail into. Here are links to the product we used in this video.

Make sure you leave half an inch out of the wall so you have space to hang your artwork. All you need to do is pre drill a hole slightly narrower than your screws then use the drill to drive a screw into the hole. Seat the round flange flush with the wall surface by tapping the screwhead. For lighter items simply screwing into the plaster with a 1 1 4 drywall screw is usually enough to get the job done.

Position the bracket on the wall and fasten it to. Amazon affiliate http amzn to 1iofrse ryobi corded drill with c. With your painter s tape rip off a piece and poke a hole in the middle of it with the pencil. Drill a pilot hole through the plaster and into the stud at each mark using a drill bit that is slightly smaller than the bracket mounting screws.

Put the hole over the x that you ve marked on the wall. Ch hanson 0304 magnetic stud finder. Plaster is a hard durable material but it s also resistant to penetration. Next make a little shelf of the wide painters tape with the sticky side up to catch the plaster that will come out of the wall when you drill.

Turn the screw to mushroom the slotted sleeve against the back wall surface. Screws and screws with masonry anchors for heavy items are your best choice for hanging things on plaster walls without picture rail. Mounting a shelf on lathe and plaster walls. When working with molly or toggle bolts screw them in until the back part has expanded completely and is securely holding the bracket to the plaster wall.

I asked our gc if he could mark the studs on the wall so that when i decided on a rack i could mount it myself.