Mounting On A Concrete Wall

When mounting on a concrete wall that has plasterboard on it you indicate above to use a 4 inch anchor rather than the 3 inch.

Mounting on a concrete wall.

Most inch fasteners require a. Continue to hammer the anchor down until the nut and washer are tight against the fixture. To the thickness of the material you re attaching to get the minimum length of screw needed. Hold the mounting bracket against the wall within the borders of the marks made in step 1.

The installation of a tapcon concrete screw is also straightforward. Concrete anchors types vary and include concrete screws hammer set anchors lag shields lead screw anchors plastic wall plugs anchor bolts and more. Using a level determine the desired height of the display before attempting to install the wall mount. Cut out and install the wall boxes that will be used for cabling.

Screw embedment will work fine. If not place a small pencil mark at the spot the mounting hole meets the wall. Attaching the mount to the brick fireplace is the next step. Mark all the screw holes that line up with the mortar joints with a pencil.

It should be a fairly tight fit. Select a screw length to penetrate the concrete at least 1 in. In hard dense materials like concrete or stone this minimum 1 in. Be sure to use the bit size specified by the fastener manufacturer.

Drop the anchor into the hole in your fixture and hammer the pin on the top of the anchor to drive it into the concrete hole you drilled earlier. For attaching something relatively light to concrete it s hard to beat the speed and ease of hammer set anchors. Masonry and concrete anchor types are considered light duty medium duty or heavy duty based on how much weight they can support. Look at where the mounting holes in the bracket line up.

Position the bracket so the screw holes line up the mortar joints between the blocks as close to the center of the marks as possible. Hammer the anchor into the hole in the concrete. Drill through a couple of mounting holes into the concrete using a hammer drill and masonry bit. When in this situation are you suggesting to achieve a 3 inch embedment of the anchor roughly into the concrete with the remaining inch effectively spanning from the face of the concrete to the face of the plasterboard.

I am showing a cheap trick when you don t want to spend the money on expensive dowels or specialized mounting devices. Just a drill and a piece of wood will.